Télécharger Imprimer la page

Electrolux XLCE Notice D'utilisation page 13

Publicité

Les langues disponibles

Les langues disponibles

Dryer Operating Sequence
1. Check that the lint fi lter is
clean and in place.
IMPORTANT!
Do not operate dryer without lint fi lter in place.
2. Load the dryer and close the door.
• Load items loosely. The average wet load will fi ll the
drum 1/3 to 1/2 full. Items need room to tumble freely
for even drying and less wrinkling.
• If desired, place a dryer fabric softener sheet on top of
the load at the beginning of the cycle.
• To save energy and time and avoid uneven drying and
wrinkling, do not overload the dryer.
• When drying large items, dry only two or three items at
a time. Fill out the load with small and medium sized
items.
• For delicate or very small loads, add two or three similar
items to improve tumbling action.
All manuals and user guides at all-guides.com
3. Select the appropriate programme and settings for each load.
4. Wake up and start the dryer.
If drying a single large or bulky item, such as a comforter,
remove the item part way through the cycle and turn it "inside
out" to maximize drying effectiveness. Place item back in
dryer and re-start cycle.
5. When the programme ends...
See «Drying Hints» and «Dryer Programme Table» for more
details.
• Close the dryer door. The dryer will not operate with the
door open.
• Push in or turn the cycle selector knob 1 or turn any op-
tion knob 2 or 3 to "wake" the dryer. You will hear three
beeps to indicate dryer is ready to operate.
• After making your selections, push in the selector knob
1 to start the cycle. You will hear one beep before the
drum begins to rotate.
• To add or remove items when the dryer is running, push
in the cycle selector knob 1 to pause the cycle and
open the door. Opening the door with a cycle running
will also pause the cycle. You will hear two beeps. Allow
the drum to come to a complete stop before reach-
ing inside. Add or remove the item, close the door and
push in the selector knob 1 again, continuing the current
cycle.
• To stop a running cycle, push in the cycle selector knob 1.
NOTE
• Remove the items promptly and hang or fold.
• You are advised to unplug the appliance.
• Clean the fi lter after every drying programme. A clean
fi lter ensures correct functioning of the appliance.
13

Publicité

loading