Electrolux XLCE Notice D'utilisation page 16

What to do if..., continued
Washer Malfunction
The appliance vibrates or is noisy:
Spinning starts late or the appliance does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly
Dryer Malfunction
Dryer does not start.
Dryer runs but won't heat.
Drying cycle takes too long, outside of the dryer
feels too hot or smells hot.
Excessive wrinkling.
If you are unable to identify or solve the problem, contact our service centre.
Before telephoning, make a note of the model, serial number and purchase date of your appliance: the Service Centre will
require this information.
16
All manuals and user guides at all-guides.com
The transit bolt has not been removed.
• Check the correct installation of the appliance.
The support feet have not been adjusted.
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the tub.
• Redistribute the laundry manually.
Maybe there is very little laundry in the tub.
• Load more laundry.
distributed in the tub. The cycle will fi nish, spinning at a reduced speed and the laundry
will be wetter than usual. In this case, redistribute the load manually and select the spin
programme.
• Redistribute the laundry.
Electrical power cord is not securely plugged in or plug may be loose.
• Make sure the plug fi ts tightly in wall outlet.
House fuse blown or circuit breaker tripped.
• Reset circuit breaker or replace fuse.
• Make sure electrical line is not overloaded and the dryer is on a separate circuit.
The button 1 has not been pressed.
• Press the button 1.
Thermal limiter tripped.
• Call authorized service person for replacement.
There are 2 house fuses in the dryer circuit. If 1 of the 2 fuses is blown, the drum may
turn but the heater will not operate. (electric models).
• Replace fuse.
Lint fi lter is clogged with lint.
• Make sure all lint has been removed from the dryer lint fi lter before starting each
cycle.
Exhaust duct requirements have not been met.
• Exhaust duct must be at least 100 mm in diameter and made of rigid or semi-
rigid metal.
• When in place, the duct must have no more than four 90° bends and must not
exceed 2 m.
Drying procedures have not been followed.
• See "Operating Instructions."
Outside exhaust hood or exhaust duct may be clogged or restricted.
• Clean out any obstruction.
High humidity.
• Use a dehumidifi er near the dryer.
Dryer is overloaded.
• Do not overload. See "Operating Instructions."
Items left in dryer too long.
• Remove items as soon as cycle ends.
Insuffi cient sorting of items.
• See "Operating Instructions."
Drying temperature too high.
• Follow fabric care label instructions.
Possible Cause / Solution
Possible Cause / Solution