Electrolux XLCE Notice D'utilisation page 18

Installation
Unpacking
All transit bolts and packing must be removed before using
the appliance. You are advised to keep all transit devices
so that they can be refi tted if the appliance ever has to be
transported again.
1. After removing all the packaging, carefully lay the appliance
on its left side. Use a rug, blanket or piece of cardboard to
protect the fl oor.
2. With a suitable spanner unscrew and remove the following
from the bottom and rear of the appliance:
• shipping bolt
• plastic spacer
• wire clip securing drain hose end
PLASTIC
SPACER
SHIPPING
BOLT
IMPORTANT!
Do NOT remove plastic clip securing the drain hose.
3. Carefully return the appliance to an upright position.
18
All manuals and user guides at all-guides.com
WIRE CLIP
PLASTIC
CLIP
Positioning
Install the appliance on a fl at hard fl oor. Make sure that air
circulation around the appliance is not impeded by carpets,
rugs etc. Check that the appliance does not touch the wall or
other kitchen units. Make sure there are no obstructing items
or material near the air-intake louvres provided at the back
(e.g. paper, rags etc.).
Level the appliance by raising or lowering the feet. The feet
may be tight to adjust, but the appliance MUST be level and
stable. Any necessary adjustment can be made with a span-
ner. The feet must never be removed.
Accurate levelling prevents vibra-
tion, noise and displacement of
the appliance during operation.
Never place cardboard, wood
or similar materials under the
appliance to compensate for any
unevenness in the fl oor.
If necessary, check the setting
with a spirit level. Improper instal-
lation could cause an increase of
vibration and noise, especially during spinning phases.