Chauvet Professional onAir IP PANEL 2 Guide Rapide page 4

EN
Wireless Operation
In optimal conditions, the onAir IP Panel 2 can operate up to 300 m (900 ft) away from the CRMX™ transmitter, The
CRMX™ receiver in the onAir IP Panel 2 must be paired with the CRMX™ transmitter for wireless operation.
Initial Setup
1. Turn the CRMX™ transmitter on.
2. Connect the CRMX™ transmitter to a DMX controller.
3. Place the onAir IP Panel 2 within 300 m from the CRMX™ transmitter.
4. Turn the onAir IP Panel 2 on.
Configuration
1. From the onAir IP Panel 2's control panel, go to DMX Address.
2. Select the start address, as with any other DMX compatible product.
3. Go to Wireless Setting > Receive On/Off.
4. Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5. Press the reset button on the CRMX™ transmitter. (The Signal Strength Indicator on the onAir IP Panel 2 will
show a ϟ in front of the bars for 3 seconds while a connection is established.)
Product Pairing
If the onAir IP Panel 2 has already been paired with the CRMX™ transmitter, the Signal Strength Indicator on top of the
display will show the strength of the signal. In this case, the onAir IP Panel 2 is ready to work in Wireless mode.
Pairing the onAir IP Panel 2 and a New CRMX™ Transmitter
1. From the onAir IP Panel 2 control panel, go to Wireless Setting > Receive Reset.
2. Select Yes.
3. From the CRMX™ transmitter, press <RESET>. The signal indicator on the transmitter will flash.
4. Once the transmitter has found the onAir IP Panel 2, the signal indicator on the CRMX™ transmitter will
illuminate solid.
5. The display screen on the onAir IP Panel 2 will show the strength of the signal.
CRMX™ operation can be interrupted or inhibited by people or liquid masses, including water or
snow, between the transmitter and receiver. For best results, keep the area between the transmitter
and receiver clear of any liquid masses.
Mounting
Before mounting this product, read the
weight of the product. Mounting clamps sold separately. For our CHAUVET Professional line of mounting clamps, go to
http://trusst.com/products.
Mounting Diagram
Mounting
clamp
3
QUICK REFERENCE GUIDE
Safety Notes. Make sure the mounting clamps are capable of supporting the
Omega
bracket
Safety cable
Secure the safety
cable using the
passageways on
the back of the
product
Junior pin screw
Junior pin
onAir IP Panel 2 QRG Rev. 4