BorMann Pro BPW5300 Mode D'emploi page 8

EN
Methods of starting and stopping the engine
START
Starter grip
4. When the engine has started, return the choke lever gradually to the fully OPEN position (at the mark).
5. Engine revolution speed is adjusted at the optimum condition before shipping from the factory. Customers can not change it. When it fails to operate
properly, connect your dealer and ask them to do the adjustment if it is necessary.
STOP
Turn the engine switch to the "OFF" position.
(Switch position may vary depending on the specifications. Refer to the instruction manual of driven equipment.)
(In case of a push button type switch, keep pressing the push button till the engine stops completely.)
● Replenish the fuel before using up completely. It will make easier at the next starting.
● When there is no subsequent work, drain the fuel from the fuel tank and restart the engine to use up the fuel remaining in the carburettor.
CAUTION
Place the engine at a horizontal position when the driven equipment is not used at the rest time, or others, in summer season. (If the tank is tilted as much as
the inside of fuel cap is submerged in the fuel, the fuel may leak.)
Do not touch the engine body, especially the muffler, during or immediately after stopping the operation.
(There is risk of burn.)
Precautions during operation
CAUTION
● Before starting operation, make sure to inspect the engine in accordance with the "Inspection before starting the engine".
● Do not operate the engine at the indoor or a place with poor ventilation. (Exhaust gas contains odourless and harmful carbon monoxide.)
● Do not insert in or approach hands or foot at the moving or rotating sections.
● Stop the engine immediately if it has been discovered any leakage of fuel or gas from the carburettor, muffler, fuel tank, crankcase, cylinder or mating face
at respective sections. (Contact a dealer or service center for repair.)
● Do not change the setting revolution speed of engine unnecessarily.
● Be careful not to touch highly heated muffler or sections on the engine to avoid possible risk of burn.
● Do not operate the engine while withered grasses, leaves or other inflammable substances are sticking in or around the muffler cover.
● Do not touch the ignition plug cap or high-voltage cord during operation. (There is risk of electric shock or physical injury.)
● Do not operate the engine with the muffler or air cleaner cover removed.
Adjusting the carburettor
Engine revolution speed is adjusted at the optimum condition before shipping from the factory. When it fails to operate properly, consult your dealer and ask
them to do the adjustment if it is necessary.
8
1. Turn the engine switch to the "ON" side.
2. Turn the choke lever to the fully CLOSED position (at the mark).
To start a cold engine, move the choke lever to the CLOSED position.
To restart a warm engine, leave the choke lever in the OPEN position.
3. Pull the starter grip lightly until you feel resistance, then pull briskly. Return the starter grip gently.
WWW.NIKOLAOUTOOLS.GR