BorMann Pro BPW5300 Mode D'emploi page 4

EN
Start-Up
ATTENTION: Become familiar with the operating procedures before starting your unit.
1) Add fresh high quality unleaded gasoline. See Engine Operation for correct amount and type.
2) Check oil level. See Engine Operation for correct amount and type.
3) Connect high pressure hose to pump outlet (See picture B).
4) Connect water source to pump inlet. There is plastic tap connector equipped with pump, connect your own connector to it, and screw tightly (see picture
A).
NOTE 1: Never pull the hose to move the unit. This could damage hose and/or pump inlet.
NOTE 2: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i. Inlet hose can connected to the water main with Max. inlet pressure
1MPa.
NOTE 3: Use cold water only and water's temperature shall not exceed 50 0C.
5) Turn water source on.
6) Turn knob clockwise and anticlockwise in order to get pencil jet and 0~40°fan jet.
Explanation:
0° Nozzle- Used for a pinpoint stream. This nozzle stream is very powerful and covers a very small area of cleaning. This nozzle should only be used on surfac-
es that can this high pressure such as metal or concrete.
15° and 25° Nozzle-Used for less powerful steam which can cover a wider area. This nozzle is also very powerful and should only be used on surfaces that can
withstand this high pressure.
40° Nozzle-Used for the least powerful stream and covers a wide area of cleaning. This nozzle should be used for most general cleaning jobs.
Operation:
NOTE: Do not let hoses come in contact with the HOT engine muffler during or immediately after use, as this will destroy the hose.
1) press the trigger safety lock, and then you can press the trigger
Trigger
Trigger safety lock
2) Start engine according to the engine owner's manual.
3) Press the trigger of high pressure gun to make sure water flowing out. Be careful when press the trigger gun, it has recoil force and the sudden torque.
Release the trigger of high pressure gun can stop the water flowing out.
In emergency condition: Turn engine off.
Shut Down Procedure
1. Release the trigger can stop the water flowing out. After did this, pls. engage the trigger safety lock to avoid accidental "switch on".
In emergency condition: turn engine off immediately .
2. Turn engine off. NOTE: NEVER turn the water off with the engine running.
3. Turn water source off.
4. Press trigger to release residual water.
5. Disconnect all hoses used
6. See storage section in this manual for proper storage procedures. Note: Let the engine cool and up to 30 minutes after use before touching.
4
WWW.NIKOLAOUTOOLS.GR