Publicité
Les langues disponibles
Les langues disponibles
pulling the drain hose farther into the
cabinet.
5
Remove the tape from the water supply line
and the electrical cable.
Connecting Water Supply
Line and Power
Connecting Water Supply Line
1
With the home water supply turned off,
connect the water supply line to the inlet valve
on the left front of the dishwasher.
CAUTION
• Tape or compound should not be used on
dishwasher inlet valve.
2
Tighten the compression nut.
3
Slide the water supply line back through the
channel, pulling gently from inside the
cabinet to make sure the line is not kinked,
pinched, stressed or crushed.
Connecting Power
The dishwasher should have a dedicated properly
grounded branch circuit to connect the 3 wire
setup which includes the ground wire.
If a 3-prong power supply is used, it should be in
an accessible location adjacent to the dishwasher
within 4 ft. (1.22 m) of the dishwasher side and not
behind the dishwasher.
NOTE
• The best location for the electrical conduit is on
the right side of the back wall. Re-route the
electrical cable before installation if the electrical
conduit pipe is longer than 3" (76 mm) and is
centered on the back wall.
1
Turn off electrical power to the unit at the
circuit breaker.
2
Use a Phillips screwdriver to remove the
screw from the junction box cover and
remove the cover.
3
Use a Phillips screwdriver to remove 2 screws
.
a
INSTALLATION
15
Publicité
