Page 1
ELAVT0001ARI ELAVT0008ARI Pre-Installation Information / Avant l’installation • Installation should be in accordance with local plumbing and electrical codes. • FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. • Additional knockout(s) are available in box(es) for alternate access hole locations. ...
Page 2
Seulement: Avant l’installation de l elavt0001ari ou ELAVT0008ARI, veillez à ce que le filtre AC (filtre 063267a - AC et Transformer Kit ou 063271a - AC filtre (vendu séparément) ait été installé conformément au manuel d’installation fourni avec le produit.
Page 3
TEMPERATURE Figure 2 1. Remove coverplate from control box. A - ELAVT0001ARI 2. Open screwdriver stop(s) to flush installation for 1 minute minimum. 3. Run water for a sufficient time so the hot and cold water supplies are as Flexible Sensor Cord Conduit hot and cold as they will get.