Télécharger Imprimer la page

Warn 85690 Instructions D'installation page 4

Kit de montage de lame pour brp commander

Publicité

Les langues disponibles

Les langues disponibles

BRP COMMANDER Mounting Kit Installation
1. Prepare the UTV by disconnecting the negative and positive
leads to the battery: disconnect the negative battery lead
first.
2. If equipped, remove the plastic side panels from both sides
of the vehicle. See Figure 1.
3. If equipped, remove the front bumper brush guard. See
Figure 2.
4. Remove the plastic bumper fascia.
5. If vehicle is equipped with a factory winch, remove fairlead,
winch and winch mounting bracket.
6. Place support brackets (2A) inside the frame of the UTV.
Align the holes in the support brackets with the holes in the
UTV frame as shown in figures 3 and 4.
©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S
Remove
4
Figure 1
Remove
Figure 2
Figure 3
85689A2

Publicité

loading