Blomberg MIS 3200 X Consignes D'utilisation page 14

3.2 Cooking levels
As a standard, there are 9 cooking levels with the digits „1" to „9" on the
display.
„A" for automatic heat-up function, „P" for booster or the symbol for „no pot"
are only displayed on the right or on the single display serving a cooking
zone
3.3 Residual heat indication
A hot cooking zone is indicated by an „H"
Overheat control for induction cooking zones
In principle, the induction works intrinsically safe.
The induction electronics provide temperature sensors at each cooking zone
being located
below the glass ceramic surface to monitor temperatures. Further
temperature sensors along
the heat sink protect the electronics itself against overheating.
This causes the „P" symbol to flash on the relevant display indicating that the
booster request cannot be dealt with currently.
3.4 Key-lock function
LED 12 serves as display of the key-lock status. In this case locking and
unlocking can be done by pressing the minus key and the special function
key (key no.2 ) of a cooking zone at the same time. This also works for
locking at one cooking zone and unlocking at another and vice versa.
Switching OFF via the ON/OFF key is also possible in locked conditions.
3.5 Break indication
While at least one cooking zone is working, the cooking zones can
be switched off by touching the general special key (key no. 2) for
more than 1 sec.
The break mode can last for max. 10 min.
10
All manuals and user guides at all-guides.com