Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17. Place the screen down into the hopper, sliding the edge
of the screen under one of the clips. Slightly bow the
screen to slide the opposite side of the screen under
the other clip. See figure 10.
FIGURE 10
CLIPS
ENGLISH
18. For most vehicles, you can keep the assembled hitch
extension bracket in its default position shown in figure
11. Attach the spreader hitch to your vehicle hitch.
Check for interference with the spreader directly behind
and out to both sides of the vehicle. Lift the spreader
at each position to make sure there is no interference
with the spreader's flow control. If there is interference
with the rear of the vehicle, assemble the hitch extension
bracket as shown at the bottom of figure 11. Tighten
the bolts and nuts when finished.
DEFAULT POSITION
FIGURE 11
7
EXTENDED
(IF INTERFERENCE)
Publicité
Table des Matières
