Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. Assemble a spacer (I), a 3/4" flat washer (G), a wheel
(air valve facing out) and another 3/4" flat washer (G)
onto the end of the axle that has both the large and
small holes. See figure 4.
8. Install a 1/8" x 1-1/2" cotter pin (E) into the small hole
in the end of the axle. See figure 4.
9. Open the bail on the drive pin (J) and install it through
the wheel and the large hole in the axle. Close the bail
to lock the pin in place. See figure 4.
(J) DRIVE PIN
(E) 1/8" x 1-1/2"
COTTER PIN

AIR VALVE

(G) 3/4" FLAT
WASHER
FIGURE 4
10. Turn the spreader upright on its wheels.
11. Insert the pinched end of the flow control rod through
the hole in the in the flow control arm. See figure 5.
FIGURE 5
ENGLISH
(I) SPACER
FLOW
CONTROL
ROD
12. Insert the hook end of the flow control rod through the
hole in the slide gate bracket located under the hopper.
See figure 6.
HOPPER
FIGURE 6
13. Assemble the flow control mounting tube to the hitch tube
using two 5/16" x 1-3/4" hex bolts (A) and 5/16" nylock
hex nuts (D). DO NOT TIGHTEN YET. See figure 7.
FLOW CONTROL
MOUNTING TUBE
(A) 5/16" x 1-3/4"
HEX BOLT
FIGURE 7
5
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
(D) 5/16" NYLOCK
HEX NUT

Publicité

Table des Matières
loading

Table des Matières