T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Max.
Hot water temp.
Recommended
Max.
Flow rate
16572XX1
16574XX1
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTA LL AT I ON CO NSID ER ATIO NS
Inspect the product before installation. Claims
for shipping damage made after installation
will not be honored.
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ The installation dimensions shown in this installation
instruction are ideal for people of approximately
6' in height. The dimensions can be changed if
required. In this case, the minimum ceiling height
of 93⅛" from the standing surface, and all other
measurements, must be changed.
⁄ The installer must ensure that the entire area of the
wall to which the mounting plate is to be mounted,
is flat (no protruding grout joints or tiles). He should
also make sure that the wall is strong enough to sup-
port the showerpipe.
⁄ The enclosed screws and anchors are suitable for
a solid surface wall. If installing in a fiberglass or
acrylic shower unit, install header boards at the
mounting points.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (49°C - 60°C)*
158°F (70°C)*
2.0 GPM (7.6 L/min) max.
1.8 GPM (6.8 L/min) max.
E N G L I S H
⁄ The mixer is equipped with check valves.
⁄ The thermostatic mixing valve is for use with shower-
heads rated at 1.3 GPM (4.9 L/min) or higher.
⁄ To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher than
120°F (49°C). In Massachusetts, the maximum
output temperature can be no higher than 112°F
(44°C).
The shower arm is intended only to hold the
showerhead. Do not load it down with other
objects.
This showerpipe is not for use as a grab bar.
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a
safe place. The receipt is required should it be neces-
sary to request warranty parts.