General Information - Novy 680/15 Instructions D'installation

GENERAL INFORMATION

General
These are the mounting instructions for the Novy hood shown on the cover. The manual is a separate booklet that
has been supplied with this hood. Read these instructions carefully before installing and commissioning the hood. It is
recommended to have one or more qualified persons carry out the installation.
Carefully take the hood from the packaging. Check if all mounting materials have been supplied using the drawings on
page 2.
The hood is to be used above a hob and/or domino and intended for household use only.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
• For easier mounting of the telescopic hood it is recommended to do this with at least 2 persons.
• Check if all mounting materials have been supplied using the drawings on page 2.
• Position the wall socket such that it is near the hood.
Exhaust or recirculation
Before starting any mounting activities, you must have made the choice if you are going to make an exhaust duct to the
outside or if you are going to use the hood as a recirculation hood. In case of an exhaust duct to the outside, carefully
read the section in these mounting instructions for installing the exhaust duct. For recirculation, please separately order
the recirculation kit.
INSTALLATION
Proceed following the mounting drawings on page 2.
PAY ATTENTION TO THE FRONT AND REAR SIDES OF THE COOKER HOOD.
The glass adjustable flap opens forwards. The lighting is installed on the rear. Carefully look at the mounting drawings!
Preparations for mounting
1
The model 680 is intended for integration into a cabinet of 60 cm wide and the model 686 is for integration into a
cabinet of 90 cm wide.
The recommended mounting height for an electrical or ceramic cooking plate is min. 600 mm and max. 750 mm. The
mounting height for a gas or induction cooking plate is min. 650 mm and max. 750 mm.
Make a cut-out:
• Type 680: 505 mm x 265 mm.
• Type 686: 805 mm x 265 mm.
• Place the cooker hood as far as possible forward, at least 16 mm.
• The cooker hood is to be mounted in a kitchen cabinet (plate thickness at least 16 mm and maximum 35 mm).
• Make sure there is a socket near the hood. It must be possible at all times to remove the power supply from the
cooker hood.
• Make sure the cabinet door is not lower than the bottom of the cooker hood.
Changing the exhaust direction of the motor (top/ rear)
2
• Change the position of the motor cover before installing the cooker hood.
• Loosen the 8 screws from the motor cover.
• Rotate the motor cover a quarter turn.
• Screw the motor cover back on.
Installing the cooker hood in the cabinet
3
• Install the cooker hood in such a way that the operating controls are to the right of the user.
• Next, push the cooker hood upward into the recess by the edges until you hear a firm click.
Mounting the cooker hood
4
• Connect the exhaust duct to the motor outlet by means of a hose clamp or aluminum tape.
• Put the plug into the wall socket.
• Open the rotating valve and hand-tighten the 4 clamping screws. Take care not to over-tighten the screws. Close
the rotating valve.
EN 9