Corsair HX750W Manuel D'utilisation page 8

WARNING: The detachable 4-pin section from the 24-pin main connector is not a "P4" /
"4-pin ATX12V" connector. Serious damage can result from using the detached 4-pin section
in place of a "P4" / "4-pin ATX12V" connector.
6 The 8-pin EPS12V connector can be separated and used as a P4 / 4-pin ATX12V
connector. If your motherboard is equipped with a P4 / 4-pin ATX12V socket
instead of an 8-pin EPS12V socket, simply separate the 8-pin EPS12V connector
into two and plug one of the halves into your motherboard. It does not matter
which half you choose.
7 If your motherboard has an 8-pin EPS12V socket, connect the 8-pin EPS12V
connector directly to your motherboard. Some motherboards have two 8-pin
EPS12V sockets. If your motherboard has two 8-pin EPS12V sockets then ensure
you connect 8-pin EPS12V cables to both of them.
8 Connect the modular cables as needed. Modular cables with blue connectors
are PCI-E power cables, while modular cables with black connectors are for
peripheral devices, such as case fans, disk drives and floppy drives.
9 The 750W/850W PROFESSIONAL includes 8 (750W) or 12 (850W) Peripheral
cables (4-pin Molex), 6 (750W) or 8 (850W) PCI-Express (6+2 Pin) cables,
and 12 SATA connectors.
10 Connect SATA or Peripheral 4-pin Molex connectors to the hard disk drives or
SSDs (repeat for additional hard disk drives and SSDs). Do not connect both a
SATA power connector and a Peripheral 4-pin Molex connector to the same drive,
unless directed to do so by the drive manufacturer.
11 The PCI-E connectors supplied with your 750W/850W PROFESSIONAL power
support video cards with both 6-pin and/or 8-pin PCI-E power sockets. Connect
the appropriate PCI-E cable(s) to the power socket(s) of your PCI-E video card if
required. If your video card requires two PCI-E power connectors, do not
connect a hard-wired/captive PCI-E connector and a modular connector to the
same video card. It is recommended to use either hard-wired/captive cables or
modular cables, but not both on the same video card.
12 Connect all peripheral devices that require Peripheral 4-pin Molex connections
such as fans and optical drives.
13 After you have connected the cables to all your devices, you may connect the
other end of the modular cables to the 750W/850W PROFESSIONAL. The blue
connectors attach to the blue sockets on the power supply, and the black
connectors attach to the black sockets on the power supply.
14 Please make sure all the cables are seated securely.
15 Connect the AC power cord to the 750W/850W PROFESSIONAL and turn on
the 750W/850W PROFESSIONAL by pushing the switch to the "I" position.
Congratulations! You have completed the installation of the 750W/850W
PROFESSIONAL power supply and your system is ready to go!
7