Yakima SwingDaddy 4 Instructions D'installation page 2

Insert tongue Into
vehIcle's hItch.
Align the holes in the
receiver to the holes in the base.
Install hitch bolt, lock-
washer, and washer.
Install bolt, lock-washer, and
washer from right side of receiver.
TIGHTEN with adjustable wrench.
remove pIn.
lIft the mast into
position
(a friend could help).
ALIGN
HOLES
15
1033439J-2/
Install safety pIn or locK
tongue to the hItch.
Install safety pin.
• Insert bolt with washer; wiggle
mast until holes align.
• Attach another washer with nut.
• Use adjustable-end wrenches or
3/4" wrenches.
• Turn wrench until tight, then
LOOSEN THE NUT 1/4 TURN.
Attach hitch lock.
or
• Attach hitch lock to end of bolt.
• Insert the key and lock the lock.
• Confirm engagement by pulling on lock.
• Close the cap.
secure mast to
tongue assembly.
• Align the mast to the tongue.
• Tighten the large wing bolt
completely.
If spAre tIre cAuses
Interference,
do not use thIs
product!