RIDGID R4222 Manuel D'utilisation page 20

ASSEMBLY
 Lift the miter lock lever to unlock the miter table.
 Press the miter detent bypass until it clicks. Release to
bypass the detent function.
 Rotate the miter table until the pointer is at the 15
position on the miter scale.
 Using a 4 mm hex key, loosen the 5 screws that hold the
miter scale/detent plate in place.
 Rotate the miter table until the blade is parallel with the
framing square.
 Push the miter lock lever down to lock the miter table.
SLIDING
MITER FENCE
FENCE
MITER
TABLE
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
SLIDING
MITER FENCE
FENCE
ROTATING
EXTENSION
MITER
TABLE
TABLE
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
BLADE
FRAMING
SQUARE
Fig. 20
BLADE
ROTATING
EXTENSION
TABLE
FRAMING
SQUARE
Fig. 21
20 - English
 Press the miter detent bypass until it clicks. Release to
engage the detent function.
 Rotate the miter scale to the 0
or until the detent engages in the detent plate.
°
 Tighten the 4 visible screws that secure the miter scale/
detent plate.
 Lift the miter lock lever to unlock the miter table.
 Press the miter detent bypass button until it clicks, then
rotate the miter table to the 15
scale.
 Tighten the remaining screw to secure the miter scale/
detent plate. Check blade squareness to fence and
readjust if necessary.
Your saw has several scale indicators. After squaring
adjustments have been made, it may be necessary to loosen
the indicator screws and reset them to zero. See Figures
23 - 24.
MITER SCALE/DETENT PLATE
SCREWS
INDICATOR
SCREW
MITER
SCALE
position on the miter scale
°
position on the miter
°
SCREWS
Fig. 22
SCALE
INDICATOR
Fig. 23