RIDGID R4222 Manuel D'utilisation page 34

OPERATION
Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
0
°
2. Miter table set right 45
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
0
°
2. Miter table set left 45
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
0
°
2. Miter table set left 45
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
0
°
2. Miter table set right 45
3. Save right end of cut
CUTTING NESTED CROWN MOLDING USING
CROWN STOPS
(Crown Stops Sold Separately as an Accessory)
See Figure 47.
Crown stops may be purchased as an accessory to this
saw for use in cutting crown molding in a nested position.
NOTE: There are two holes in each miter table extension.
The crown stop may be installed at either location for making
the desired type of cut.
To attach the crown stops to the extension table:
 Position a crown stop on the extension table.
 Insert the threaded crown stop lock knob through the
long slot in the crown stop and into Hole A as shown, but
do not fully tighten to allow for adjustment of the crown
stop.
 Set the top of the piece of crown molding on the table.
Position the spring angles so that the bottom angle is flat
on the table and the top angle is flush against the miter
fence.
 Tighten the lock knob securely before making the cut.
NOTE: Hole B is used for extended miter cuts when the
rotating extension table is in the farthest outboard posi-
tion.
REPOSITIONING THE SLIDING MITER FENCES
See Figure 48.
The sliding miter fences may be repositioned for making
miter cuts when additional support is needed closer to the
saw blade. This is helpful when making 45° miter cuts for
crown molding and baseboard.
To reposition the miter fences:
 Unplug the saw.
 Loosen the fence lock knob on the back of each sliding
 Lift and remove the sliding miter fences.
°  Place the left sliding miter fence on the right side of the
 Reinstall the sliding fences so that they drop into the slot
 Tighten the fence lock knob securely for each sliding
°
 Perform a dry run prior to making any cut after repositioning
°
°
34 - English
fence section.
tool and the right sliding miter fence on the left side.
in the fixed fence and slide inward until fence stops.
miter fence.
the sliding miter fences to ensure there is no interference.
HOLE "B"
CROWN
STOP
CROWN
STOP
LOCK KNOB
HOLE "A"
Fig. 47
FENCE
LOCK KNOB
Fig. 48