RIDGID R4222 Manuel D'utilisation page 12

FEATURES
SWITCH
SELF-RETRACTING LOWER BLADE GUARD
TRIGGER
TRIGGER
LOCKOUT LEVER
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SLIDE BAR
When unlocked, the saw arm will glide forward and backward
the length of the slide bar for cutting various workpiece
widths.
SPINDLE
SLIDE LOCK KNOB
LOCK
BUTTON
SLIDING
The slide lock knob locks and unlocks the sliding feature
MITER FENCES
of this tool.
SLIDING MITER FENCES
See Figure 6.
The sliding miter fences help support the workpiece securely
when making most cuts. The sliding feature allows for
clearance of the saw blade when making bevel or compound
cuts. Some cuts may require that the sliding fence be
removed completely to avoid interference between the fence
and the blade.
Loosen the fence lock knob before attempting to slide the
fences or lift them for removal. Once the desired position of
the fence is determined, retighten the fence screw securely.
SPINDLE LOCK BUTTON
See Figure 6.
The spindle lock button locks the spindle (keeps the saw
SWITCH
blade from turning). Depress and hold the lock button only
TRIGGER
while installing, changing, or removing the saw blade.
PADLOCK
SWITCH TRIGGER
See Figure 6.
The saw will not start until you depress the trigger lockout
lever and squeeze the switch trigger. To prevent unauthorized
use of the compound miter saw, disconnect it from the power
supply and lock the switch in the OFF position. To lock the
switch, install a padlock (not included) through the hole in
the switch trigger and make certain the switch is inoperable.
If the switch is still operable with the padlock installed, a
Fig. 6
padlock with a larger shackle diameter must be used. Store
the padlock key in another location.
12 - English