Terminal Connections; Circuit Diagram - auna 10006684 Mode D'emploi

Terminal Connections

Connections as illustrated below
Note
tighten the screws frimly, but be coreful not
to apply too much force* as doing so many
damage thee screws.
*the torque value shouold be less than 1N•m

Circuit diagram

First, place the unit where you plan to install
it, and mark postion of the four screw holes
on the surface of teh mounting board (not)
supplied). Then drill the hoes approximately 3
millimeters (mm) in diameter and mount the
unit onto the board with the supplied moun-
ting screws are 15 mm long. Therefore, make
sure that the mounting board is thicker than
15 mm.
11