Fuse Replacement - auna 10006684 Mode D'emploi

4. BASS BOOST level control
Turn this control to boost the frequencies around 50 Hz
to a maximum of 12 dB.
5. TREBLE BOOST level control
Turn this control to boost the frequencies around 10 KHz
to a maximum of 12 dB.
6. LEVEL adjustment control
The input level can be adjusted with this control when using
source equipment made by other manufacturers. Turn it to MAX
when the output level of the car audio seems low.
7. Cut-off frequency adjustment control
Sets zhe cut-off frequency (50-250Hz) for the high-pass filter.
If the fuse blows, check the power connection an replace the
fuse. If the fuse blows again after replacement, there may be an
internal malfunction. In such a case, consult your nearest goods
dealer.
Warning
When replacing the fuse, be sure to use one matching the am-
plfier stated above the fuse holder. Never use a fuse with an
amperage rating exceeding the one supplied with the unit as this
could damage the unit.
Caution
• Befor making any connections, disconnect teh ground terminal of the car battery to avoid short
circuits.
• Be sure zo use speakers with an adequate power rating. If you use small capacity speakers, they
may be damage.
• Do not connect the „-"terminal of speaker system to the car chassis and do not connect the "-"
terminalof teh right speaker with that of the left speaker.
• Install the input and output cords away from the power supply lead as running them close together
can generate some interference noise.
• This unit is a high powered amplifier. Therefore, it may not perform to its full potential if used with
the speaker cords supplied with the car.
• If your car is equipped with a computer system for navigation or some other purpose, do not
remove the ground wire from the car battery. If you disconnect the wire, computer memory mqay
be erased. To avoid short circuits when making connections, disconnect the +12V power supply lead
until all the other leads have been connected.

Fuse replacement

10