Numatic George Mode D'emploi page 13

Information for wet and dry use vacuum cleaners
Warning!
Read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines.
As with all electrical equipment, care and attention must be exercised at all times during use,
in addition to ensuring that routine and preventative maintenance is carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render this
equipment unsafe and the manufacturer can accept no responsibility in this respect.
The machine shall be disconnected from the mains by removing the plug from the supply socket during cleaning or
maintenance and when replacing parts or converting the machine to another function.
The machine is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of
experience or knowledge, unless they have been given supervision or instruction.
Children being supervised are NOT to play with the machine. This appliance is intended to be assembled, cleaned and
maintained by an adult. This machine is not a toy.
Caution
If foam/liquid comes out of machine exhaust, switch off immediately. Allow the accumulated liquid to drain out through the
machine exhaust, check the float assembly to ensure correct operation, empty the container if full of liquid, reassemble the
machine. Immediately upon start up there will be a certain amount of liquid issuing from the machine exhaust which will
be the residue of liquid still within the power head. This will be quickly discharged after which the machine should function
normally.
Liquid ejected from the machine could be hazardous as a result of its temperature, pressure or chemical content.
This machine is not suitable for the collection of biological hazards, hazardous or explosive dust. You should contact your
local distributor if you require a machine capable of performing these tasks.
Ensure that the filtration system fitted to the machine is suitable for the material being collected.
This machine is for indoor use only. This machine shall be stored indoors only. .
When moving from one place to another, consider the weight of the machine.
Notes
You must ensure that the filtration system fitted to the machine is suitable for the material being collected.
This product complies with the requirements of IEC/EN 60335-2-69 2012.
The primary use for this machine is commercial, for example in hotels, schools, hospitals, factories, shops and offices.
If the vacuum cleaner stops working, remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet, and inspect the floor tool, wands
and hose for debris. If the floor tool, wands and hose are clear, replace the dust bag and clean the filter.
The vacuum cleaner should be inspected after use for damage.
The power light will illuminate, when your machine is connected to a suitable power supply (where fitted).
Do
• Use a bag and filter at all times when using 'dry'.
•
Keep your machine clean.
•
Keep filters clean.
•
Regularly clean the water level limiting float safety valve and examine for signs of damage or correct operation.
•
Keep hoses and tubes clear.
•
Replace any worn or damaged parts immediately.
•
Regularly examine the power cord, if damage is found, power cord must be replaced by a qualified person using the
correct Numatic original part.
•
Keep diffuser filter (where fitted) clean.
Don't
•
Use steam cleaners or pressure washers to clean the machine or use the machine in the rain.
•
Immerse in water for cleaning.
•
Allow any inexperienced repairs. Call the experts.
•
Use wet if float valve is not functioning or fitted.
•
Use to suck up hot ashes, or lighted cigarette ends.
•
Run the machine over the power cable during operation as a hazard may occur.
•
Pull on the cable to unplug the machine from the power supply.
•
Walk over-wet carpets, upholstery or fabrics.
•
Walk on clean carpets until fully dry.
•
Spray onto people or animals.
•
Attempt machine maintenance or cleaning unless the power supply plug has been removed from the supply outlet.