Roadstar CLR-4200FR Manuel D'instructions page 4

All manuals and user guides at all-guides.com
POWER SUPPLY
This unit operates from a main supply of 230V ~ 50Hz. Connect the AC
power cord to the AC household main outlet. Ensure that the voltage is
as indicated on the rating plate on the rear of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time
and alarm settings in the event of a temporary power interruption.
Install a 3-volt flat lithium battery (type CR-2032) not included, into the
battery compartment located on the bottom of the unit.
If power is temporarily interrupted the display will blink and the radio will
not play. However, the battery back-up circuit will continue to maintain
the clock and alarm settings. When power is restored the clock will
display the correct time and alarm settings, and no adjustment is
necessary.
Note: If power is interrupted and there is no battery in the compartment
or the battery is exhausted. The time and alarm settings will be lost.
When
power is restored the clock will begin to flash indicating that the time and
alarm settings must be corrected.
INTRODUCTION
The unit is designed to automatically synchronize its current time
and date with radio signal generated from DCF-77 Frankfurt,
Germany. We suggest to place the Antenna (15) in a suitable free
from obstacles area to ensure maximum reception of radio signal.
3 4
English
SETTINGTHE LCD DISPLAY USING THE RADIO SIGNAL
1. Connect the Power, the unit start searching the Radio Controlled
signal and you can see the Antenna tower icon flashing in the right
side of the display.
The search signal stop automatically after 10 minutes, but in case
if fail in receiving, is possible to set the clock manually by keeping
pressed 4 seconds the Snooze button (2).
If the Radio signal is OK, the Antenna Tower Icon will keep
displaying and the time will take 3 - 10 minutes to complete the
setting.
SETTINGTHE CLOCK MANUALLY
1. In the normal Display mode, to set the Clock, keep pressed
CLK ADJ (3) Button until the YEAR digits will flash. Press UP/
DOWN (4-9) to adjust the YEAR digits.
2. To set the MONTH, press CLK ADJ (3) once more and the
MONTH digits will flash. Press UP/DOWN (4-9) to adjust the
MONTH digits.
3. To set the DAY mode, press CLK ADJ (3) once more and the
CLK ADJ (3) digits will flash. Press UP/DOWN (4-9) to adjust the
DAY digits.
4. To set the 12/24 mode, press CLK ADJ (3) once more and the
Year digits will flash. Press UP/DOWN (4-9) to adjust the 12/24
5. To set the HOUR, press CLK ADJ (3) again and the HOUR
digits will flash. Press UP/DOWN (4-9) adjust the HOUR digit.
6. To set the MINUTE, press CLK ADJ (3) again one more time
and the MINUTE digit will flash. Press UP/DOWN (4-9) to adjust
the MINUTE digit.
7. Press the CLK ADJ (3) button to conclude the setting.
English