Assembly & Installation; Tool Operation - Power Fist 8843542 Mode D'emploi

8843542
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Air Drill
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
INSTALL AIR PLUG
Prepare a standard 1/4 in. NPT male air plug for use with your tool.
1. Wrap the external threads of the male plug with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2. Screw the plug into the tool's air inlet and tighten with a wrench until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the tool. A
quick coupler may then be used to connect the leader hose to the air line hose.
OPERATION
PRESSURE DROP
Apply the air consumption and pressure rate numbers to the tool's air inlet, not
the compressor's outlet. Calculate the pressure drop for your air supply set-up
and increase the compressor outlet pressure to compensate. Make sure you do
not exceed the maximum pressure for any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure the air
pressure and adjust the compressor's output.

TOOL OPERATION

1. Clean the air drill of packing grease before first use. See the Air Tool
Lubrication section for instructions.
8
3/8 in. Pistol Grip Reversible Air Drill
• Chuck Key • Air Plug (Male)
For technical questions call 1-800-665-8685
V1.0