Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
6.
Always use the correct chuck size. If the chuck size is larger than the
accessory shank size it will not grip the shank properly, leading to
possible injury to the operator, damage to the tool or work piece.
7.
Always check accessory bits for damage before each use. Damaged
accessories can break during use and cause serious injury.
8.
Never use dull or damaged bits. Sharp bits must be handled with care.
Damaged bits can snap during use. Dull bits require more force to push
the tool, possibly causing the bit to break.
9.
If devices are used for the connection of dust extraction and collection
facilities, ensure these are connected and properly used. Use of a dust
collection system reduces dust-related hazards.
10. Maintain a firm grip on the tool and position your body and arms to allow
you to resist kickback forces. Kickback will propel the tool in the direction
opposite to the tool's movement at the time of snagging.
11.
Use metal and voltage detectors to locate hidden electric, water or gas
lines. Avoid touching live components or conductors.
12. Before drilling, check that there is sufficient clearance for the drill bit
under the workpiece.
13. If you are interrupted when operating the drill, complete the process and
switch off the tool before looking up.
AIR TOOL PRECAUTIONS
1.
Use only clean and dry compressed air as a power source. Contaminated
or moist air will gradually damage the tool.
2.
Install an in-line shutoff valve or regulator to allow immediate control over
the air supply in an emergency, even if a hose is ruptured.
3.
Discontinue tool use if it does not work properly or air is leaking. Tag or
mark the tool as 'defective' or 'out of service' until repaired.
4.
Check the manufacturer's maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated to never
exceed the maximum pressure rating of the tool (see Specifications).
Exceeding the maximum PSI rating can create a bursting hazard, causing
injury and property damage.
5.
Attach all accessories properly to the tool before connecting the air
supply. A loose accessory may detach or break during operation.
6.
Never use oxygen, combustible gas or any other bottled gas as a power
source. Any power source other than an air compressor could cause an
explosion and serious personal injury.
Visit www.princessauto.com for more information
3/8 in. Pistol Grip Reversible Air Drill
8843542
5
Publicité
Table des Matières
