Assembly & Installation; Install The Handle - Power Fist 8843567 Mode D'emploi

8843567
9. Before using the tool on a workpiece, test the tool by running it at the
highest no load speed for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the tool
to determine the cause.
10. Never touch the tool accessory or workpiece during or immediately after use.
They may be hot and could inflict a burn injury.
11. Never use a tool with a cracked or worn tool accessory. Change the tool
accessory before using it.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Air Drill
• Auxiliary Handle • Auxiliary Handle Holder
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.

INSTALL THE HANDLE

Screw the handle (#37) onto the handle ring (#38). Adjust the handle position
by loosening the handle, rotating it to the desired position, then retightening
the handle.
INSTALL AIR PLUG
Prepare a standard 1/4 in. NPT male air plug for use with your tool.
1. Wrap the external threads of the male plug with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2. Screw the plug into the tool's air inlet and tighten with a wrench until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
8
1/2 in. Pistol Grip Reversible Air Drill
• Chuck Key • Air Plug (Male)
For technical questions call 1-800-665-8685
V1.0