Technical Data; Installing The Appliance - Royal Catering RCWF-10LE-H Manuel D'utilisation

10. ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other liquids.
11. Under no circumstances should the housing be opened.
12. Do not place your hands of legs near the rotating parts.
III. TECHNICAL DATA
Product name
Model
Article No.
Nominal power supply [V]
Frequency [Hz]
Rated power [W]
Dimensions (L x W x H) [mm]
Cylinder dimensions (diameter / height) [mm]
Capacity [L]
Funnel dimensions [mm]
Weight [kg]
IV. SCOPE OF THE APPLICATION
The electric sausage stuffer is designed for manufacture sausages, cured meats etc. of different sizes.
The user is liable for any damage resulting from non-intended use of the device!
V. BERORE THE FIRST USE
Upon receipt of the goods, check the packaging for defects and open the packaging if there are no damages.
If the packaging is damaged, please contact your transport company and distributor within 3 days, and
document the damages as detailed as possible. Do not turn the package upside down! When transporting
the package, please ensure that it is kept horizontal and stable.
VI. DISPOSING OF THE PACKAGING
Please keep all packaging materials (cardboard, plastic tapes and Styrofoam), so that in case of a problem, the
device can be sent back to the service centre in accurate condition!
VII. INSTALLING THE APPLIANCE
Positioning the machine
The machine should be positioned on a dry and stable surface, as well as vertically in order to prevent
movement during operation. The machine should be positioned on a flat and even surface, with sufficient
load capacity for the machine and its contents. Ensure unobstructed access to the electricity plug at all times.
Make sure the power source reflects the parameters on the rating plate! Prior to the first use remove and
wash all elements and wash the entire machine.
10
Electric sausage stuffer
RCWF-10LE-H RCWF-15LE-H
1347 1348
230~
50
230 260
310 x 410 x 650 310 x 410 x 770
225 x 270 225 x 400
10L 15L
16, 22, 32, 38 16, 22, 32, 38
26 28,5
Rev. 21.01.2017
VIII. MACHINE OPERATION - BASICS
1
6
2
7
8
9
3
4
10
5
11
12
1
3
4
5
2
Machine operation:
1. Set both switches to "0".
2. Connect the power cable to the machine and then connect the plug to a socket.
3. Lift the piston by setting the switch on the left-hand side to "I".
4. When the piston reaches its maximum height, the motor will stop automatically. Set the switch to "0"
and disconnect it from power source by removing the plug from the socket.
5. Before starting, clean the entire machine and in particular the elements which come into contact with
foodstuffs (piston, cylinder, etc.). In order to remove the metal cylinder from the machine, tilt it until the
discharge nozzle lifts up. There may be some resistance at first, since the cylinder has special fastening
elements which prevent any displacement during operating.
Rev. 21.01.2017
Machine description
1. Piston guide rod
2. Power cable with plug
3. Cylinder handle
4. Discharge nozzle
5. Base plate
6. Motor housing
7. Piston
8. Metal cylinder
9. Supports
10. Cylinder legs
11. Foot pedal
12. Plug
Control panel description:
1. Move the piston up
2. Move the piston down
5 3. STOP
4. Fill function on/off switch
5. Piston movement rate adjustment knob
6. Control socket
11