SLIM FIT
• Repair the possible obstruction of the blower or the electro; if the error
persists, replace the blower or electro (remove the outside cover of the unit
in order to access the blower or electro; for the blower, also remove the
evaporator cover).
• Replace the 5A fuse. To access the electro or blower fuses, it is necessary to take
down the access cover from the control panel mounted on the front.
• Replace the electronic plate.
!
(If the error persists, contact the Authorised Technical Service).
• Correctly connect the control module terminals (see attached wiring diagram).
• Replace the module(s).
• Replace the compressor(s).
• Check the pressure (the compressors disconnect after 6 bars); if necessary,
recover gas and load 250 g again per circuit.
!
To access the compressors, modules or load connection points, it is
necessary to take down the access cover from the control panel mounted on
the front.
!
(If the error persists, contact the Authorised Technical Service).
• Reprogramme the remote control.
• Replace the remote control's battery and reprogramme.
• Replace electronic control.
• Replace the remote control.
!
(If the error persists, contact the Authorised Technical Service).
Solution
19
Air conditioning for vehicles
EN