Centaur JohnBean Manuel D'utilisation page 6

P/N: EAL0424G33A
P/N: EAL0413G13A
P/N: 8-23562A
6
Safety
INSTRUCTION: Safety Label
Meanings
WARNING:MAKE SURE THAT THE SAFETY
SIGNS ARE ALWAYS CLEARLY VISIBILE
IN THE POSITIONS INDICATED BY THE
MANUFACTURER (SEE FIGURE AT THE SIDE).
For any reset, use the Part Number (P/N) listed at
the side.
EAL0413G13A
General Danger.
Take the necessary precautions.
The areas marked with this symbol indicate the
•
presence of a potentional ranger to the operator.
This plate is normally found with a second
•
pictogram, which represents the type of risk
in greater detail. The operator must know the
meaning of every pictogram found on the machine.
When this symbol is found without other plate, it
•
notifi es the operator of a general risk, refer to the
User Manual for the warnings.
Do not operate the machine without knowiong
•
the meaning of the pictogram found in the area
concerned.
Do not allow unauthorised people approach the
•
machine.
IN ORDER TO USE THE MACHINE THE
OPERATOR MUST KNOW THE MEANING OF ALL
THE PICTOGRAMS FOUND ON THE MACHINE.
8-23562A
Electrical risk. Electric shock hazard.
Do not operate equipment with a damaged power
•
cord or if the equipment has been dropped or
damaged, until it has been examined by a qualifi ed
service person.
If an extension cord is necessary, a cord with a
•
current rating equal to or greater than that of the
equipment should be used. Cords rated for less
current than the equipment can overheat.
Unplug equipment from electrical power outlet
•
when not in use. Never use the cord to pull the
plug from the outlet. Grasp plug and pull to
disconnect.
Do not expose the equipment to rain. Do not use
•
on wet surfaces.
Plug unit into correct power supply socket.
•
Do not remove or bypass grounding wire.
•
CONTACT WITH HIGH VOLTAGES CAN CAUSE
DEATH OR SERIOUS INJURY.
IMPORTANT!! SAVE THESE
INSTRUCTIONS
....... .......
-