Degometal GO 212 Consignes De Sécurité Et Mode D'emploi page 26

SYMPTOM
More than one operation
of the trigger needed to
place fastener
Tool will not grip stem of
fastener
Jaws will not release
broken stem of fastener
Cannot feed next
fastener
Slow cycle
Tool fails to operate
Fastener fails to break
POSSIBLE CAUSE
Air leak
Insufficient air pressure
Lack of lubrification
Worn or broken jaws
Low oil level or air in oil
Build up of dirt inside the nose assembly
Worn or broken jaws
Build up of dirt inside the nose assembly
Loose jaw housing
Weak or broken spring in nose assembly
Incorrect component in nose assembly
Rotary valve incorrectly adjusted
Build up of dirt inside the nose assembly
Jaw housing , nose tip or nose casing not
properly seated
Weak or broken spring in nose assembly
Air or oil leak
Low oil level or air present in oil
Broken stems jammed inside tool
Rotary valve incorrectly adjusted
Lack of lubrification
Low air pressure
Build up of dirt inside the nose assembly
No air pressure
Damaged trigger valve 41
Loose base cover 35
Loose stem collector
Insufficient air pressure
Fastener outside tool capability
Low oil level or air present in oil
www.degometal.com
REMEDY
Tighten joints or replace components
Adjust air pressure to within
Lubricate tool at air inlet point
Fit new jaws
Prime tool
Service nose assembly
Fit new jaws
Service nose assembly
Tighten against locking ring
Fit new spring
Identify and replace
Read "operating procedure"
Service nose assembly
Tighten nose assembly
Fit new spring
Tighten joints or replace components
Prime tool
Empty stem collector
Check jaws spreader is correct
Adjust air pressure to within
specification
Adjust as in "operating procedure"
Lubricate tool at air inlet point
Adjust air pressure to within
Service nose assembly
Connect and adjust to within
Replace
Tighten
Tighten retaining nut 21
Adjust air pressure to within
Use more powerful tool
Prime tool
26