Automatic Programmaing Of Coffee Serving (Single Or Double Serving); Operating Instructions; Coffee Preparation; Dispensing Of Coffee In Manual Mode - SM 85 FLEXA Serie Manuel D'instructions Pour L'emploi

4.3 Automatic programming of coffee serving (single or double serving)
1. Turn the machine off by turning the main switch 1.
2. Press and hold key B (single coffee) and while doing so turn on the machine. The machine will enter pro-
gramming mode and the LED of push button B will flash.
3. Prepare the machine to dispense a single coffee and set the cup under the dispensing spout.
4. Press once on key B. Once the desired amount of coffee is reached in the cup, press key B again to stop
dispensing and thus memorize the length of time of dispensing.
Repeat the same steps (from point 1 on) for the double serving (key C).

5. Operating instructions

5.1 Coffee preparation

During the flow of espresso coffee, tea or steam, these substances can cause burns due to acci-
dental skin contact.

5.2 Dispensing of coffee in manual mode

1) Prepare the machine to dispense either a single or double coffee.
2) Press and release key A (manual coffee) to start dispensing coffee.
3) Once the desired serving amount is reached in the cup, press A again to stop dispensing.

5.3 Dispensing of coffee in automatic mode

1) Prepare the machine to dispense either a single or double coffee.
2) Press and release key B (single coffee) or key C (double coffee) to start coffee dispensing.
3) Once the programmed serving amount has been reached, dispensing will stop automatically.

5.4 Pre-infusion mode

Dispensing of coffee with pre-infusion mode can be enabled or disabled as the user desires by pressing key
D (the LED of the key signals whether this mode is active or not).

5.5 Drawing hot water

Hot water is drawn by the spout 9 and can be used to prepare infusions, tea, camomile tea, to heat cups, to
add water to an espresso and to obtain American-style coffee, and so on.
Use the hot water drawing lever 8 (lowering it, raising it or moving it to the side) to dispense hot water from
the spout.

5.6 Drawing steam

A jet of steam, which can be used to foam milk or to heat other liquids, comes out of the steam drawing spout 7
as follows: by raising or lowering the lever 6 you attain the maximum flow (the lever stops in the maximum posi-
tion. To stop the flow of steam, place the lever back in its original position); if you move the lever sideways you
will obtain reduced steam flow (the lever does not block, and if released it goes back to its original position).
20