Power Fist 8732315 Mode D'emploi page 15

V1.0
1. Insert the slotted handle end over the release valve.
2. Open the release valve by slowly rotating the handle counterclockwise.
The load will descend as pressure is released from the jack' s system.
Control the speed by rotating the handle.
a. Rotate the handle counterclockwise to increase the speed.
b. Rotate the handle clockwise to decrease the speed.
3. Open the release valve fully once the ram has fully retracted.
4. Position supports, like jack stands, if the load will remain above ground
for an extended period. Consult the support device's manual for proper
placement.
5. Once the supports are carrying the load, open the valve to allow the ram
to retract fully.
6. When the work is done, raise the load enough with the jack to carefully
remove the supports.
HAND WINCH OPERATION
WARNING! Do not release the handle when the ratchet mechanism is
disengaged and there is a load on the line. The load will drop and can
cause a serious impact injury. The crank handle will also spin and can
cause a minor impact injury. Maintain a firm grip while unwinding until
the load is settled and there is slack in the wire rope.
The ratchet lever has 2 positions. The upper position is for winding the wire
rope onto the drum with the ratchet in gear. The lower position disengages the
ratchet pawl allowing the drum to freewheel in either direction.
WINDING/UNWINDING (NO LOAD)
1. Rotate the handle slightly to release pressure on the pawl.
2. Push the ratchet lever down until it clicks to disengage the ratchet
mechanism.
3. The drum can move freely in both directions.
4. Grasp the hook and pull the wire rope until the hook can be attached to
the load.
• Be careful as the crank handle will rotate freely and can cause an
impact injury if it strikes you.
5. Rewind any excessive wire rope by turning the crank handle. Make sure
the rope winds evenly onto the drum.
Page 15
TRUCK MOUNT CRANE
www.princessauto.com / 1-800-665-8685
8732315