Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
6.
Hold the end of the wire rope in place. With your other hand, remove the
wire rope's slack by pulling it back through the holes, until the loop traps
the rope end.
7.
Reel the new wire rope onto the drum by turning the handle, being careful
not to allow kinking.
8.
Test the winch for proper operation.
MOUNTING A NEW WIRE ROPE
1.
Route the end of the new wire rope under the bushing and through the
hole to the outside of the drum.
2.
Insert the wire rope under the cable clamp.
3.
Tighten the cable nut securely.
4.
Reel the new wire rope onto the drum by turning the handle, being careful
not to allow kinking.
5.
Test the winch for proper operation.
INSTALLING THE CHAIN AND HOOK
Make sure the chain, hook and hardware are rated to exceed the crane's weight
capacity.
1.
Choose a short length of chain to avoid problems with clearing obstacles
when raising the load.
2.
Attach a suitable shackle to the top chain link.
3.
Align the shackle openings with the connection point on the boom
extension. Insert a bolt through the shackle and the connection point.
Secure the bolt with a nut or tighten if the shackle is threaded.
4.
Attach another shackle and a hook to the bottom chain link, if the chain
does not have one already.
OPERATIONS
WARNING! No one other than the people involved in moving the load
should be in or on the vehicle. Anyone near the vehicle may be seriously
injured or killed if the load falls or the vehicle tips over under a heavy
load. Ensure each person has an unobstructed escape route away from
the work area.
Page 13
TRUCK MOUNT CRANE
www.princessauto.com / 1-800-665-8685
8732315
Publicité
Table des Matières
