Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8732315
wire compacted. Run the winch with a light load several times, before normal
use.
Also use a weight when spooling the wire rope onto the winch. This will
provide the correct tension when spooling.
INSTALLING A WIRE ROPE
1.
Remove the bolt that connects the boom and boom
extension and set aside.
2.
Push the boom extension into the boom.
3.
Lift the boom so it is at a slight upward angle. The
angle will hold the boom extension in place.
4.
Insert the end of the wire rope through the hole in the
bottom of the boom extension. Pull several feet of wire
rope through the hole.
5.
Feed the wire rope down the boom extension and
boom until it comes out the other end.
6.
Place the wire rope onto the pulley in the boom and
boom extension.
7.
Continue pulling wire rope out of the boom until you
are sure it won't be pulled back by its own weight.
8.
Mount and wrap the wire rope onto the winch.
MOUNTING A NEW WIRE ROPE
1.
Pull the end of the wire rope over the top of
the drum.
2.
Insert the wire rope end through a side hole
in the drum from the inside. Pull about one to
two feet of wire rope out.
3.
Guide the wire rope into the next hole and pull
the excess through. Leave enough line to form
a large loop.
4.
Guide the wire rope through the next hole from the inside and pull the
excess through.
5.
Insert the end of the wire ripe under the large loop. The end must extend
past the loop, but stay within the edge of the drum to avoid impeding
rotation.
www.princessauto.com / 1-800-665-8685
TRUCK MOUNT CRANE
V1.0
FIGURE 7.
FIGURE 8.
FIGURE 9.
Page 12
Publicité
Table des Matières
