Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8732315
2.
Check the mounting location below the truck bed
to avoid wiring, gas tanks, mufflers, etc. Adjust the
base position if needed to avoid puncturing the
understructure when drilling.
3.
Use the base as a template and mark the holes that
you will use to mount the base to the truck bed.
Move the base aside.
4.
Drill holes into the truck bed. Make sure the drill and
drill bit are suitable for drilling through the metal.
Use cutting oil if necessary.
5.
Reposition the base over the holes. Secure in place
with bolts, washers and nuts (sold separately). Only
use hardware that exceeds the weight capacity of
the crane.
6.
Insert the bearing (#43) into the base. Screw the base
handle (#34) into the base until the bearing is held in
place (Fig. 2).
7.
Slide the post over the base and align the holes in
each (Fig. 3). Insert a bolt (#27) through each hole.
Slide a washer (#8) and lock washer (#7) over the
bolts and secure with a nut (#6).
8.
Insert the boom into the post' s top bracket (Fig. 4).
Position the large pulley inside the boom so the
bushings align with the bolt holes. Insert a bolt (#42)
through the bolt holes. Secure with a washer (#24),
lock washer (#23) and nut (#22).
•
Ensure the connection point for the hydraulic
jack is on the bottom and near the post when
connecting the boom.
9.
Follow the instructions for
10. Slide the boom extension into the
boom. Until the hole in the boom
aligns with the hole at the 2,000 lb
mark.Insert a bolt (#21) through the
bolt holes. Secure with a washer (#24),
lock washer (#23) and nut (#22).
www.princessauto.com / 1-800-665-8685
TRUCK MOUNT CRANE
Installing The Jack in the next section.
V1.0
FIGURE 2.
FIGURE 3.
FIGURE 4.
FIGURE 5.
Page 10
Publicité
Table des Matières
