Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
11.
Follow the instructions for
INSTALLING THE JACK
WARNING! The hardware (bolts, pin, washers, lock washers and
nuts) used to attach the jack to the equipment must be capable
of withstanding the load without deforming or breaking to prevent
equipment failure and/or personal injuries.
The hardware is included.
1.
Align the ram' s bolt hole with the bolt
hole on the equipment's attachment
point. The attachment point location will
vary depending on the equipment and
application.
2.
Insert a bolt (#21) through the mounting
points and the ram's bolt hole.
•
Secure the bolt with a washer (#24),
lock washer (#23) and nut (#22).
3.
Place the the clevis mount over the clevis
attachment point on the equipment and
align the bolt holes.
4.
Insert a bolt (#27) through the clevis mount and attachment point. Secure
with a washer (#24), lock washer (#23) and nut (#22).
INSTALLING THE WINCH
Remove the wire rope from the winch before installation.
1.
Prepare the hardware by sliding a lock washer (#39), then a washer (#38)
over the each bolt (#37). Set aside within easy reach.
2.
Position the winch's base on the post. The winch's handle will be on the
right-hand side. Align the base's bolt holes with the post's screw holes.
Hold the winch in place.
3.
Insert one of the prepared bolts through the base's bolt holes and screw
the bolt into post. Repeat with the other three prepared bolts. Tighten
each bolt until the lock washer begins to compress.
BEFORE FIRST USE
The steel rope must be broken-in before using to lift a heavy load. The break-in
process will stretch the cable, ensure the individual wires are seated and the
Page 11
TRUCK MOUNT CRANE
Installing The Chain And Hook.
www.princessauto.com / 1-800-665-8685
8732315
FIGURE 6.
Publicité
Table des Matières
