Polaris 9350 Spot Manuel Du Propriétaire page 9

•
•
•
•
•
•
•
•
•
When the control unit is powered on with the Àoating
cable attached, the operating time for the current
selected cycle is displayed.
The Polaris robotic cleaner includes a safety feature
that automatically stops the cleaner if it is powered on
but not submerged in water. For pools equipped with a
beach area, this safety feature is programmed to drive
the cleaner in reverse and back into the pool when the
impeller is out of the water.
1. Submerge the cleaner in the pool and remove
any air trapped inside by keeping the unit
vertical (Figure 15).
1
2. Ensure the unit sinks to the bottom of the pool
and does not Àoat (Figure 16).
2
3. Spread out the Àoating cable over the pool,
ensuring there are no kinks or coils in the
cable (Figure 17).