Polaris 9350 Spot Manuel Du Propriétaire page 23

The control unit will display one of ten different error codes to indicate speci¿ c problems with either the control unit or
mechanically with the cleaner.
• To remove an error code after troubleshooting, press any key and the control box turns off.
• If an error code is displayed and no key pressed, the screen goes into standby mode after 10 minutes of inactivity.
Press any key to turn the screen back on.
• When an error is detected, programming for the control unit is temporarily suspended. The
turned off.
Press and hold the button to clear the error code and reactivate current programming.
(7) Cleaner Àoats on the surface.
•
•
•
•
•
• Clean the ¿lter canister.
•
•
•
•
•
• Check connection of the Àoating cable on the
•
•
button is