Polaris 9350 Spot Manuel Du Propriétaire page 12

The automated Lift System makes removing the cleaner
from the pool simple. The Lift System will move the
cleaner toward the edge of the pool then drive it to the
surface for removal.
1. At the end of the cleaning cycle, or at any time
during a cleaning cycle, press
the automated lift procedure.
Press and hold the Lift System button to turn
cleaner to the left. Cleaner will keep rotating
left. Once the cleaner is oriented towards the
wall of your choice, release the button.
Press and release the Lift System button and the
cleaner will drive up the wall and to the water
line and wait to be retrieved.
The screen displays
Lift System is in operation.
2. When the cleaner is within arm's reach,
handle to remove from the water
19). Never lift the cleaner out of the pool by the
Àoating cable.
to begin
when the
use the
(Figures 18,
1
2
3
The Polaris 9550 Sport and P955 robotic cleaner comes
with a handheld remote control stored on the cleaner
caddy next to the control unit. The remote control is
factory-synchronized to your cleaner's control unit.
• To turn on the remote control:
Press (see Figure 20) and hold for 3 seconds.
The display shows
cleaner is now operating in remote control mode.
• To pilot the cleaner, point the device toward the
cleaner in the water and move directionally as shown
in Figure 21.
to indicate the