Polaris 9350 Spot Manuel Du Propriétaire page 19

2
3. To install a new brush, position the new
brush on the roller with the spikes facing
downwards (Figure 32).
3
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot (Figure 33).
4
5. Use a pair of scissors to cut the tabs 3/4 inch
from the heel so that they are no higher than
the spikes (Figure 34).
6. Repeat this procedure to install the second
brush.
1. Pull on the inside of the old tire to remove the
tire lip from the wheel (Figure 35).
2. Remove the old tire (Figure 36).
3. To replace the tire, position the tire on the
wheel making sure to orient the tire so that the
word INSIDE is toward the body of the cleaner
(Figure 37).
1
2