ATH-Heinl M52 Mode D'emploi page 55

1
2
3
4
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
4 3 1
2
Press the pedal down slightly so that the rotary plate
moves clockwise.
Once the pedal has been pressed down as far as it will go,
switch into the faster 2nd gear.
Pull the pedal upwards to move the rotary plate
anticlockwise.
Press the pedal to work with the bead breaker blade.
When you release it again, the bead breaker blade will
return to the starting position.
The clamping claws open in the first position.
The middle position (gently pressing the pedal) allows you
to close the clamping claws and set them to the wheel
being used.
The clamping claws are fully closed in the final position.
Press the pedal to swing the assembly tower backwards.
Press it again to swing the assembly tower forwards again.
When you press the button (1), both the hexagon (2) and
the square (3) are held in the position that has been set.
These can be unsecured again by pulling the button and
released to adjust the assembly head (4).
Manufacturer ATH-Heinl GmbH & CO.KG
- 5 -