Disposal - Conrad Electronic Raveland Power Package 2 Notice D'emploi

There is background noise:
• The earthing cable is not connected properly. Remove any rust or paint from the contact surfaces.
• The earthing point of the car radio and of the amplifier are not on the same potential, try different earthing points.
• The cables of the amplifier are positioned too close to the cables for the ignition system of the vehicle.
• The ignition system is not shielded.
• The cables of the amplifier input are installed too close to the power supply cables.
The amplifier switches on and off during operation:
• The earthing cable does not have proper contact. The cable or the battery terminal might be corroded.
• The voltage supplied at the +12V connection of the power terminal (14) is too low, the cable or the battery terminal
is corroded, the battery is weak.
• Loose contact of the remote cable, REM connection of power terminal (14) has a loose contact or is corroded.
No bass is audible:
• One loudspeaker is connected with reverse polarity.
• The bass control on the car radio is set to minimum.
• The active switch is not set correctly.
Mid-high-ranges are not played:
• The active switch is not set correctly.
• The high-range control of the car radio is set to minimum.
Repairs other than those described above should only be carried out by an authorised
specialist.

15. Disposal


At the end of its service life, dispose of the product according to the relevant statutory regulations.
40