Connecting The Amplifier Outputs; Connecting The Speaker Inputs - Conrad Electronic Raveland Power Package 2 Notice D'emploi

10. Connecting the amplifier outputs

a) Connecting the speaker inputs
The car amplifier is equipped with for 4 loudspeaker outputs.
2 loudspeaker outputs each can also be used in mono-bridge mode to supply one loudspeaker. This, however,
significantly increases the power output.
The satellite loudspeakers are connected in stereo mode, the subwoofer in mono-bridge mode (3-channel mode).
The loudspeakers must be connected using two-core cables. Insulate the bare wires at the
connecting terminals. Make sure no cables are damaged by sharp edges.
Only use loudspeakers with sufficient capacity (see „Specifications").
Make sure that the loudspeakers are connected with the correct polarity, i.e. plus and minus
signs match!
The amplifier is designed for a loudspeaker impedance of at least 2 ohms (stereo mode) or 4
ohms (mono-bridge mode). Never connect loudspeakers with lower impedance.
• Connect the loudspeaker connections of the satellite loudspeakers to the SEAKER FRONT connection (16) on
the amplifier.
Positive terminal of the left satellite loudspeaker > LEFT+ connection
Negative terminal of the left satellite loudspeaker > LEFT- connection
Positive terminal of the right satellite loudspeaker > RIGHT+ connection
Negative terminal of the right satellite loudspeaker > RIGHT- connection
• Connect the loudspeaker connection of the subwoofer to the SPEAKER REAR (17) connection on the amplifier.
Connection (+) of the subwoofer (red terminal) > BRIDGED+ connection
Connection (-) of the subwoofer (black terminal) > BRIDGED- connection
33