Operation; The Active Switch Of The Amplifier - Conrad Electronic Raveland Power Package 2 Notice D'emploi

11. Operation

a) The active switch of the amplifier
The amplifier is equipped with an active switch which allows you to switch a high-pass or a low-pass filter for the rear
channels. One high-pass filter is provided for the front channels.
The separation frequencies can be adjusted continuously.
The REAR frequency crossover switch (2) influences the active switch for the rear loudspeaker outputs:
• FULL
If the active switch is switched off, the amplifier plays the complete frequency range.
• HPF
If the high-pass filter is switched on, the amplifier only plays the frequency range above the frequency set by the
REAR HPF control (1).
• LPF
If the low-pass filter is switched on, the amplifier only plays the frequency range below the frequency set by the
REAR LPF (3) control.
The FRONT frequency crossover switch (10) influences the active switch for the front loudspeaker outputs:
• FULL
If the active switch is switched off, the amplifier plays the complete frequency range.
• HPF
If the high-pass filter is switched on, the amplifier only plays the frequency range above the frequency set by the
FRONT HPF control (11).
35