Connecting The Amplifier Inputs - Conrad Electronic Raveland Power Package 2 Notice D'emploi

9. Connecting the amplifier inputs

The amplifier is equipped with 6 RCA inputs to be connected to the car radio.
Car radios with RCA outputs can be directly connected to the input sockets. If your car radio is only equipped with
loudspeaker outputs, a suitable audio frequency adapter is to be used for the connection.
For the connection of the RCA inputs, only use suitable shielded RCA cables. The use of other
cables might cause interferences.
Keep the length of the RCA cables as short as possible.
Do not install the RCA cables close to other cables. This way, you can avoid interferences in
the amplifier input.
To avoid distortions or mismatches that could damage the amplifier, the RCA inputs must only
be connected to source devices equipped with RCA outputs. Also note the information under
„Specifications".
• Connect the RCA outputs of you car radio to the RCA inputs of the amplifier.
Rear outputs > REAR IN connection (6)
L = left input
R = right input
Front outputs > FRONT IN connection (8)
L = left input
R = right input
• If your car radio does not have 4 RCA outputs, please use a Y adapter.
80H 80H
32
REAR REAR
HPF HPF LPF LPF Gain Gain
6 0
12 12
SUPER SUPER
BASS BASS
2K 2K 50H 50H 250H 250H Min Min
HPF LPF FULL HPF LPF FULL
IN IN OUT OUT IN IN
L
Max Max
R
FRONT FRONT
Gain Gain HPF HPF
POWER POWER
PROTECTION PROTECTION
Min Min Max Max 80H 80H 2K 2K
FULL FULL HPF HPF