babymoov Digital Green Notice D'utilisation page 20

Problem
• The transmitter is not transmitting.
• The transmitter is transmitting
all the time.
• The "Out of range" alert
does not switch off.
• The "Out of range" alert is not working.
• The temperature alarm
does not switch off .
• The battery low alert does not switch off.
• The charge runs out quickly.
• On the receiver screen both transmitters
have the same number.
• The speaker produces
a lot of feedback and interference.
• The range of the transmitter is too small.
20
TROUBLE SHOOTING
Possible cause
• The receiver is off.
• The microphone's sensitivity is too low.
• The batteries are exhausted or the mains
adapter is not correctly plugged in.
• The microphone's sensitivity is too high.
• The pairing has failed.
• The transmitter's batteries are exhausted.
• The "Out of range" alert is activated on the
transmitter but inactivated on the receiver.
• The distance between the transmitter and
the receiver is too great.
• The "Out of range" alert is inactivated on
both appliances.
• The "Out of range" alert is activated on the
transmitter but inactivated on the receiver.
• The maximum and minimum
temperatures defined are too close to the
ambient temperature.
• The batteries are exhausted.
• The battery is damaged.
• The nightlight is on all the time
• The vibrator function is activated.
• During the pairing the same number was
attributed to both transmitters.
• The transmitter is placed close to other
electric appliances.
• The two appliances are separated by
metallic structures.
• The transmitter's batteries are exhausted.
BABYPHONE DIGITAL GREEN • Instruction Manual
Solution
• Switch the receiver on.
• Increase the microphone's sensitivity with the
"Up" button (2).
• Replace the batteries or check the
connection.
• Reduce the microphone's sensitivity with the
"Down" button (3) so that the transmitter
reacts to the voice.
• Carry out another pairing.
• Replace the batteries or use the mains adapter.
• Activate the "Out of range" alert on
the transmitter.
• Bring the receiver closer to the transmitter.
• Activate the alert on both appliances.
• Activate the alert on the receiver.
• Adjust the maximum and minimum
temperatures: they must be about 5 °C
above and below the temperature displayed
on the appliance.
• Recharge the battery with the mains
adapter (receiver). Replace the batteries or
use the mains adapter (transmitter).
• Replace the battery with a new battery.
• Switch off the nightlight or set it to VOX.
• Inactivate the vibrator function.
• Carry out another pairing by giving a
different number to each transmitter.
• Change the positions of the electric
appliances or move the transmitter away
from the source of interference.
• Move the transmitter or receiver.
• Replace the batteries or use
the mains adapter.