SNOWJOE SJ618E Manuel D'utilisation page 7

4. Secure the middle frame to the lower frame using 2 knobs
and 2 carriage bolts. Install the knobs on the outside of
the unit, and tighten (Fig. 4).
Fig. 4
5. Align the holes in the bottom of the lower frame with those
on the unit (Fig. 5).
Fig. 5
Square
J-bolt
6. Secure the lower frame to the unit using 2 knobs and 2
J-bolts. Install the knobs on the inside of the unit, and
tighten (Fig. 6).
Fig. 6
Chute Crank Assembly
1. Remove the cotter pin from the lower crank rod (Fig. 7).
Fig. 7
2. Insert the pin-hole end of the lower crank rod into the
opening at the back of the housing with holes aligned
(Figs. 8 – 10).
Fig. 8
Handle knob
Fig. 9
7
Cotter pin
Lower crank
rod
Housing
opening