Replacing The Belt - SNOWJOE SJ618E Manuel D'utilisation

6. Install the replacement auger by following the above steps
in reverse order.
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow thrower
beneath the rotor housing (Fig. 36).
Fig. 36
Scraper
bar
2. Remove the screws that secure the scraper to the snow
thrower (Fig. 37).
Fig. 37
The screws that secure the scraper bar
3. Install the new scraper bar and fasten it securely to the
snow thrower with the screws.

Replacing the Belt

NOTE: Under normal operating conditions, it should not be
necessary to replace the auger belt. However, should the auger
jam or malfunction, the belt could be damaged. To replace the
belt, follow the instructions.
NOTE: Determine the left and right hand side of the snow
thrower by standing behind the unit in the normal operating
position.
1. Open the left side plate by removing the five screws
(Fig. 38).
Fig. 38
2. Use your right hand to turn the rib side of the belt
up and pull upwards while turning the auger pulley
counterclockwise with your left hand. The belt can be
easily removed from the pulley (Fig. 39).
Fig. 39
3. Put the belt on the drive pulley first and then place the
belt at the lower end of the auger pulley (Fig. 40).
Fig. 40
14
Screws
Screws
Belt
Auger pulley
Drive
pulley