Powering On And Off - SNOWJOE SJ618E Manuel D'utilisation

4. Secure the carriage bolts and knobs. Make sure the knobs
are tightened (Fig. 22).
m
CAUTION!
Ensure the carriage bolt is fully aligned with
square hole on the chute to ensure a secure fit. Then, tighten
completely.
Fig. 22
Carriage bolt
5. Turn the chute control crank clockwise to ensure the
discharge chute and deflector are in position.
Operation
NOTE: Before using this machine, make sure that the power
source you will use complies with the specifications detailed
in this manual. Before inserting the plug into the socket, verify
that the snow thrower's auger and rubber plates are firmly
secured, and that the rubber plates are facing the correct
direction. Perform a test run to ensure that the rotor turns
freely.
Securing the Extension Cord
1. For safe and efficient use of your snow thrower, use only
a UL-rated extension cord recommended for outdoor use.
Refer to the Extension Cord Chart on page 2.
2. Push a loop of the extension cord through the slot on the
cord lock from the opposite side of the restraint hook.
Position the loop over the hook and pull the cable back
through the slot (Fig. 23).
Fig. 23
Extension
cord
Slot
3. Insert the female end of the extension cord into the
appliance's polarized male plug (Fig. 24).
Fig. 24
4. Note that the snow thrower has a polarized male plug –
one prong in the plug is slightly longer and wider than the
other (Fig. 25). The extension cord female end should be
likewise polarized so that the extension cord fits snugly
into the appliance plug.
Fig. 25
m
WARNING
Damaged electrical cords present risk of fire,
electrical shock, and serious bodily injury.
Before operating the snow thrower, carefully examine
the electrical cord. If the cord is damaged, do not use
the snow thrower. Replace or repair the damaged
cord immediately. If you need assistance, contact an
authorized Snow Joe
Powering On and Off
m
WARNING!
The auger starts rotating immediately
after the snow thrower is switched on. Keep hands
and feet away from the auger.
1. To power on, depress and hold the safety switch button
found alongside the switch housing (Fig. 26).
2. While depressing the safety switch button, pull the
ON/OFF switch lever toward you. Once the machine
powers on, release the safety switch button and begin
operation (Fig. 26). The machine can only be started by
depressing the safety switch button first, followed by
squeezing the ON/OFF switch lever; reverse operation will
not start the machine.
10
m
+ Sun Joe service center.
® ®