Unpacking
Carton Contents:
• Electric snow thrower with upper handle
• Middle frame
• Lower frame
• Discharge chute
• Chute deflector
• Upper crank rod
• Lower crank rod with cotter pin
• Crank rod connector
• Handle knobs/deflector knobs (8)
• Square J-bolts (2)
• Carriage bolts (6)
• Thumbscrews (2)
• Chute screw
• Manual with registration card
1. Carefully remove the electric snow thrower and check to
see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
+ Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric snow
thrower. The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations or save the packaging for long-term
product storage.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
Assembly
m
CAUTION
Inspect wiring, which, if damaged during shipping, may
cause serious bodily injury during equipment use. If
any damage is seen or suspected, do not assemble.
Instead, contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
customer service center at
®
m
+ Sun Joe
customer
®
®
Upper, Middle and Lower Frame
Assembly
1. Align the holes in the upper handle with those in the top of
the middle frame (Fig. 1).
Fig. 1
Handle
knob
2. Secure the upper handle to the middle frame using 2
knobs and 2 carriage bolts. Install the knobs on the
outside of the unit, and tighten (Fig. 2).
Fig. 2
3. Align the holes in the middle frame with those in the top of
the lower frame (Fig. 3).
Fig. 3
Handle
knob
6
Carriage bolt
Carriage bolt